How To Guide

Step 1

Place teeth tray in boiling water by the tag for 2-3 seconds then remove.

Step 2

Place the teeth tray over your teeth and suck out the air. Use your fingers to firmly mould the tray to your teeth, taking care as it can be hot. Remove when you feel that the mould has taken on shape and place in cold water to insure the shape holds. (if unhappy with fit repeat steps 1&2)

Step 3

Cut off the tag and if needed trim the teeth tray around the gumline to keep the gel off the gums. Repeat steps 1-3 for the second teeth tray.

Step 4

Brush your teeth prior to treatment then place a small drop of whitening gel in the middle of each tooth indent on both trays.

Step 5

Place both trays in mouth. Turn the LED activator light on and place under your lips. The LED light automatically beeps and turns off after a 10min cycle to help you keep time. Reactivate until the desired duration is acheived. We recommened starting 30-40 minutes and increasing based on sensitivity.

Step 6

Remove both trays and rinse your mouth with warm water. Lightly brush your teeth again to remove any excess gel. Clean your teeth trays with the toothbrush to prepare them for the next treatment.
Smile and enjoy your White Diamond smile! 🙂

Follow us on Instagram

This error message is only visible to WordPress admins

Error: No connected account.

Please go to the Instagram Feed settings page to connect an account.